PRIVATE · DEV BUILD
710 Console DEV
The current DEV build, packaged to run on another Windows PC (Ethan's, downstairs) as a remote client of the station. No installer, and .NET doesn't need to be installed.
Set up Ethan's PC
- Close any older 710 Console DEV on Ethan's PC, then download the zip above.
- Right-click the zip → Extract All… → choose Desktop. You get a 710Console-DEV folder. Replace the old one if asked.
- Open the folder and run 710Console-DEV.exe. If Windows SmartScreen appears: More info → Run anyway (the DEV build isn't signed).
- In the audio setup, pick Ethan's own headset/speakers and microphone. Skip the radio USB audio: the radio isn't on this PC.
Connect to the station
- On the laptop: run 710 Console DEV, press Connect to the radio, and leave it running. It is the station.
- If Ethan's PC is already saved as a computer: on Ethan's PC open Remote and press Connect next to the saved station.
- If not: on the laptop open Remote Setup → Direct / VPN and press Start direct hosting. It shows a 6-digit pairing code (valid 5 minutes). On Ethan's PC open Remote Setup, choose the Direct / VPN client, and enter the laptop's address and that code. Ethan's PC saves the station, so next time it's just Connect.
- On Ethan's PC, AUDIO & TX tab: set Remote audio quality → Maximum and set the MIC slider (the PC mic level on Ethan's PC).
Your audio settings
Already work remotely
They live on the laptop (the station), which applies them to Ethan's voice before it reaches the radio:
- eSSB voice chain, profiles and EQ
- USB MOD gain (SSB and FM)
- SSB voice profile, TX BPF
- Radio USB audio routing
- TX time limit
Set on Ethan's PC
They belong to the PC you're sitting at:
- Headset/speaker and microphone
- MIC (PC mic) level
- Remote audio quality
- AF volume
- Theme, layout, scope look
The laptop and Ethan's PC should run the same DEV build. After rebuilding DEV, republish this page and update Ethan's PC too.